Separate names with a comma.
Left/right.
If he does auto restoration he should be able to fix it with lead.
You can solder lead quite nicely. A small torch, a little flux and a popsicle stick to form the solder and Bob's your uncle.
One of the guys here has a Goth. It seems like very good boat. Don
I guess I should have mentioned that this "helluva mess" doesn't hurt the mold at all. It cleans up with water quite nicely. Do like Hew says,...
This works great with one exception, don't try to use water based primer over PVA. The primer dissolves the PVA and you get a helluva mess. Don
If the mold has had a couple of hulls pulled out of it you really just have to freshen the wax with a single coat. That said there is no harm in...
Picture please Earl :D Don
I use 3 lays of 4 oz. and it's about .015"/.5mm thick, not worth the trouble of re-sizing all the frames in my opinion. Don
The sheer strips will try to straighten out the hull. Just glue them in and then re-establish the hull shape with spreaders. I use two sheer...
Where did I write that? What post? That must have been a while ago:confused:
This is how I do it. It's the amount and where to put it that is defeating me.
It's been a while, I think I pulled it tight(ish). That would make it easier to set up and every sail would be the same. Remember that I'm not...
I take my pictures from the top. It makes the seam lengths more equal in the picture. Neat program isn't it. For comparisons I pull the leach...
here ya go! http://www.uksailmakers.com/Resources/AccuMeasure.html I've found that the best way to get the draft right is to keep records and...