Separate names with a comma.
Thanks for response. I am thinking of trying a hollow version of cross arms. Most of mine have been solid. Thought about a vertical thin ply...
Chad - don't be too quick. After resetting my password (see above post) I get an error message trying to access the forums. Need some...
A post references an attachment by number. Clicking on that "link" results in an error notice that there is no such link/number and the requested...
I'm getting an invalid/incorrect password error when trying to sign in. Says my name is already in use too Dick
Claudio is correct in that you don't have to be signed in to see the forum topics and posts. The benefits of signing in are the ability post or...
Nice. Are cross arms metal, or fiberglass. Foam filled or hollow? Thanks
Yup - I did notice a few visits. Miss ya.
Rod - As the above "author" (and volunteer moderator) with no pony in this race, I ask and point out that we seem to be carrying a lot of "dead...
FYI - just checked. We have 38 subscribers who have joined prior to December 31, 2004 with only 1 post. A couple I recognize and wonder if...
Good points To clarify - we have subscribers from 2004 with a single (introductory) post. Personal opinion: in 12 years, there is...
Try doing a few test layups to learn. Use epoxy as it is easier to mix correctly and doesn't smell. Take a block of wood, lay on wax paper...
As noted in the RG65 thread - I came very close to 'binning" my narrow RG65 because of surface finish issues. (See post for all the info - don't...
Two possibilities when asking a friend who shoots skeet here ..... Higher price = a shop that has a lot of reloading customers. Must keep stock...
Thanks Claudio - I feel a little better knowing even the "Master" has one that didn't turn out as envisioned. ;)
Well, disaster (of sorts) struck. Some time back, I tried to coat my nARROW balsa strip hull with epoxy, and ran into a lot of fish-eyes in the...
Claudio - I was also looking for posts from people who didn't have an IP address. Regarding deletions, and your suggestions - I would leave final...
Good luck Clark. You know - with adequate lubrication, You can craft the bulb size needed from wood. (use a lathe if you have access to one) and...
This site replaced the old one back about early 2000's, and while reviewing subscribers, I noticed a pretty long list of people who wanted to...
If you have any firearm/hunting stores where you are ...... ask if they have any #9 lead shot (used to reload shotgun cartridges) for shooting...
Looking pretty good. Keep on working toward the finish. Dick