Separate names with a comma.
Nope, cleared the cache and it still takes me to the old "what's new" page, then if you click on "rcsailing.net forum" it takes you into the old...
Yes!!!!! I've been chugging away on the old one lol. If I type in RCsailing.net it goes to the old landing page and then into the archive one....
Oh, a silly point - I would change the "label" system. I've been given "senior member" which I assume is based on post count. Senior Member gives...
Thanks for the heads up. I'll make a plaster mold then and if the weight is considerably out, I can use that to pour the lead.
It formats very well on the Phone.
Thanks Dick!! I can't get no9 anywhere but I can get no7 which is pretty close according to here: http://www.shotgunworld.com/amm.html Which...
Here's a weird point of view...... This site has a ridiculous wealth of knowledge with regards to building methods etc. Most of these methods...
I think my build is going so slowly because I'm avoiding the mold/cloth layups in case it goes wrong. So I start on the next thing that doesnt...
Hello gents. Thanks for the info Dick, there's a great ammo shop right near me. I'll swing by and ask them :) Clark, glad you got an idea to try...
The bulb.... I kept whacking numbers into the bulb calculator and came up with this shape. It gave the lowest wetted surface which is what I...
Believe it or not I am making progress - very slowly. Here is a pic of the hull with lots of sanding done and the beginnings of a deck. [ATTACH]...
That is incredibly close to the plans. I must look for a local distributor I attempted a clever way of doing a keelfin. It was atrocious...
Thank you Dick, Unfortunately our exchange rate has decided to kill any idea of buying anything based abroad. We went from about 10:1 to 16:1...
[ATTACH] Starting to be nice and smooth. I worked out that a 0006 profile will be 3mm at the top of the fin so I think I'll try for a 009...
So a raised deck it shall have! There is the side profile in the one set of drawings. Does anyone have input on the radius/angle for the raised...
And a happy new year to you too :) I just got back from camping in sweltering heat so I need to catch up on the discussion :)
I've been filling and sanding before glassing the plug as practice using body filler. I suddenly thought I should measure the width at the station...
I had a sudden thought, If the wind hits the hull it will be diverted up and cause turbulence of the wind layer( not sure of the correct term)...
Hello gents :) When I got the hull planked I giggled to myself when I tried to imagine fitting the electronics in your V5 skinny ones. It must be...
I then started planking. I shall refrain from any input as I did a horrible job with many holes. Fortunately It's going to be a plug so it doesn't...