Separate names with a comma.
I have a thread for SeaWind servo replacement and weights at RC Groups, Sailboats. The last entry is as follows: Kit Keel: 52.75 oz. Readyset...
Sailrt posted his Readyset weight on 3/26/14, and his weights are about the same as mine. It appears the Readyset is just overweight. Similar...
I am in Gaithersburg, MD
I realized, after some time, that my Readyset mainsail has only one batten, at the top, and is missing the lower four. Being out of warranty,...
Weight of Seawind Readyset. I bought my Seawind Readyset in June 2014. I weighed it on the 14th of Feb. 2015: Boat without Keel or hatch cover...
I am concerned that if some water gets into the hull, which has flotation material, that it would never dry out and would get moldy. What are...
While adjusting rudder linkages with the rear hatch removed, I found it difficult to replace the hatch. It came into 3 pieces: the hatch cover,...
Go to website, wichitarcsailing.org That is the Air Capital Model Sailing Club. Go to, For Sale, and see the hatch cover, with photo. I use...
Racer944, Please see thread, Hatch Cover Alternative Sources. Go to website, wichitarcsailing.org That is the Air Capital Model Sailing...
Eric, What do you use for a charger for LiFe batteries? I am just using NiMh now.
[ATTACH][ATTACH][ATTACH][ATTACH][ATTACH] These are photos of my sail.
I have a Readyset, new this Spring. The mainsail has a vertical curve or roll, along the mast, extending 1/4th the width of the sail. It is...
I have purchased a hatch kit from Fresh Seawind Upgrades, freshwind1@att.net, for $20. This is a Lexan hatch plate, three guides, and a tubular...
I have a serious rudder position problem. I fiddle it over and over, but with the servo activated, the rudder is always several degrees off from...
I have tried foam insulation tape, and it deforms too much. An alternative was offered, or illustrated, some time ago, with three screws. Is...
Jerry, my son lives in Arnold, MD, on Bay Green. Is there a sailing venue there? Alan
The power switch on my new Readyset SeaWind requires a two pin connector, which matches the supplied battery holder connector. All of my other...
I have just purchased a new Seawind from an ebay source. I sail a Victoria with the Maryland Model Yacht Club, in Columbia, MD, and with the...